SR EN RU

Y BEARING UNITS

UYU 205 2S

Y-Bearing Plummer Block Units With Grey Cast Iron Housing "U"

3D view

Technical Specification
dBore diameter25mm
LOverall length 70mm
AHousing contact surface width36mm
A1Width of the top of the housing22mm
HHousing height69.5mm
H1Distance from the contact surface to the bearing axis36.5mm
JPitch circle diameter50.8mm
GThreadM12mm
G1Thread length15mm
s1Distance from locking device side face to raceway centre 23.5mm
kgMass0.68kg
CdynDynamic load rating14kN
CoStatic load rating7.8kN
PuFatigue load limit0.335kN

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing

UYU 205 2S

×

UYU 205 2S

×

Sealing Type:

Single seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing.

UYU 205 2S

×

We value your privacy!

We and our partners are using technologies like cookies to give you the best possible experience when using our website. This enables us to bring you relevant and personalized content. We also use it to analyze traffic on our website. Some cookies are required for the site to function and cannot be turned off. Your privacy is important to us, so we are asking for your permission to use these technologies.

Visit our Privacy policy to learn more about how we process your data.