SR EN RU

UK 210 2S+H 210

Y-Ball Bearings With Tapered Bore

3D view

Technical Specification
dBore diameter50mm
DOutside diameter 90mm
BWidth inner ring 20mm
C Width outer ring 20mm
d1Outer diameter inner ring 62.5mm
EDistance from raceway centre to the hole for lubrication 6.4mm
d2Bore diameter-adapter sleeve45mm
D1Hole diameter78.2mm
L Width adapter sleeve55mm
WKM nut outside diameter70mm
YKM nut width12mm
CdynDynamic load rating35kN
CoStatic load rating23.2kN
PuFatigue load limit0.695kN
kgMass0.44kg

Tehnical Drawing

Sealing

S SEAL / S SEAL (2S)

Single lip seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing. The friction and speeds are the same as with RS but provides much better protection against the rough impurity particles. This is very good sealing system: the sheet part protects the seal from the soil, dust and rough particles. At the same time makes the labyrinth with the rubber part. The rubber part provides contact sealing which prevents penetration of finer impurities, water, moisture, steam etc. Suitable for neutral conditions because of the presence of the foreign materials. It is used with the Y bearing (standard) and deep groove ball bearings.

Sealing Drawing

UK 210 2S+H 210

×

UK 210 2S+H 210

×

Sealing Type:

Single seal with the labyrinth between the sheet part and the rubber lip which conducts the contact sealing.

UK 210 2S+H 210

×